Three-Dimensional Analysis of a Composite Repair and the Effect of Overply Shape Variation on Structural Efficiency / Najlacnejšie knihy
Three-Dimensional Analysis of a Composite Repair and the Effect of Overply Shape Variation on Structural Efficiency

Kód: 08138163

Three-Dimensional Analysis of a Composite Repair and the Effect of Overply Shape Variation on Structural Efficiency

Autor David A Sutter

This research characterizes, in the elastic range, a scarf joint with overply using digital image correlation photogrammetry and finite element modeling. Additionally, the effect of varying the overply's geometric profile is exami ... celý popis

69.36


Skladom u dodávateľa
Odosielame za 14 - 18 dní
Pridať medzi želanie

Mohlo by sa vám tiež páčiť

Darujte túto knihu ešte dnes
  1. Objednajte knihu a vyberte Zaslať ako darček.
  2. Obratom obdržíte darovací poukaz na knihu, ktorý môžete ihneď odovzdať obdarovanému.
  3. Knihu zašleme na adresu obdarovaného, o nič sa nestaráte.

Viac informácií

Viac informácií o knihe Three-Dimensional Analysis of a Composite Repair and the Effect of Overply Shape Variation on Structural Efficiency

Nákupom získate 172 bodov

Anotácia knihy

This research characterizes, in the elastic range, a scarf joint with overply using digital image correlation photogrammetry and finite element modeling. Additionally, the effect of varying the overply's geometric profile is examined. Specimens are constructed from AS4/3501-6 prepreg with a [0/ 45/90]2S layup. A fixture is used to achieve a consistent scarfed hole in each panel. The patch and adhesive (FM 300) are co-cured to the panels using positive pressure, which minimizes repair porosity. Three variations in the overply geometry are used: circular, rooftop-end, and tooth-end. The full strain field in each uni-axially loaded specimen is captured using digital image correlation photogrammetry (ARAMIS). These results validate an ABAQUS 3-D finite element model of a scarf patch with circular overply. Good correlation is evident in the longitudinal strain; strain sensitivity limits correlation in the transverse and shear directions. The finite element model is used to identify peak out-of-plane stresses in the repair joint. Significant normal stresses occur at edge of the overply and at the inner scarf diameter. Finally, the experimentally-measured strains of the 3 overply variations are examined. Variation in strain magnitude is insignificant; the strain gradient at the overply edge, however, is significantly lower on the profile with the tooth-edge.

Parametre knihy

Zaradenie knihy Knihy po anglicky Society & social sciences Education

69.36

Obľúbené z iného súdka



Osobný odber Bratislava a 2642 dalších

Copyright ©2008-24 najlacnejsie-knihy.sk Všetky práva vyhradenéSúkromieCookies


Môj účet: Prihlásiť sa
Všetky knihy sveta na jednom mieste. Navyše za skvelé ceny.

Nákupný košík ( prázdny )

Vyzdvihnutie v Zásielkovni
zadarmo nad 59,99 €.

Nachádzate sa: